Drill Master 500X Instrukcja Użytkownika Pobierz pdf (Strona 9)

Pre-Season Test

This test should be done prior to every planting season. You will have to have the implement hooked to

tractor with hydraulics available. The tractor will remain stationary.

1. This test should be done after completing the

INITIAL SETUP on page 6.

2. Turn power toggle to ON position, and

RUN/HOLD toggle to HOLD.

3. Enter CAL mode by pushing and holding CAL

soft key until red warning light is steady on.

4. Turn center rotary switch to TEST SPEED. Use

+ or - soft key to adjust speed you plan to run in

the field.

(Example: 5.0 mph)

5. Turn hydraulics on.

NOTE: There is a check valve on the hydraulic

hoses which prevents the motors from

running backwards. However, on initial

start up they may momentarily run

backwards.

6. Push AUTO/MAN soft key so AUTO is displayed

on screen.

7. Make sure all necessary Section toggles are in

the ON position.

8. Put RUN/HOLD switch to RUN. Lower planter to

activate mercury switch. Hydraulic motors should

now be running; if not, make sure hydraulics is

selected in correct direction and Section switches

are on.

9. Now that motors are running, put center rotary

switch on METER RPM and you should have a

rpm reading on the display. Shut off Section

toggle switches one by one and you should

continue to get a rpm reading until the last section

is shut off. This verifies that all shaft sensors and

poppet valves on motors are working.

10. With everything still running, turn all Section

toggles ON that are being used. Switch to HOLD.

11. Push and hold CAL to get out of calibration.

12. Push AUTO/MAN button to enter manual mode.

13. Move center rotary selector to RATE.

14. Switch RUN/HOLD toggle to RUN.

15. Push and hold “+” soft key. Hydraulic motors

should speed up to maximum speed.

16. Push and hold “-“ soft key. Hydraulic motors slow

down to almost a stop.

17. This verifies the PWM valve is working properly.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Drill Master 500X Instrukcja Użytkownika Strona 9

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Elektronarzędzia Drill Master 500X